Quick resolutions to 'Version mismatch!' messages


If you're getting a version mismatch error please refer to below, depending on whether it's happening when you're calling SSIS or Stored Procedures.


In Stored Procedures:

Go to your sample scripts folder that's included with your install, which by default is located: "C:\mSQL\scripts"  or "C:\matchIT SQL\scripts" if you upgraded from an older version.

run the following SQL query’s located in the above directory:




You may need to change the USE statement at the top if you're using a non-default database to house your Assembly/Stored Procedures. 

The Stored Procedures need to be dropped and recreated after any install/upgrade, normally the matchIT SQL configurator will handle this for you at the end of the install, but if you're upgrading from an older version the configurator will not come up for you, you would need to uninstall/reinstall before seeing it, but its normally just easier to remember to run the above 2 scripts after an upgrade.



Failure to install new SSIS components when upgrading to a newer version of matchIT SQL:

In rare cases the mSQL installer can fail to install new SSIS components, leaving the previous components still installed on the computer. The result is that an SSIS package created with an older version of mSQL will, when executed, stop with an exception such as "Version mismatch! (assembly=0x01040800 service=0x02000000)".

The issue is most likely to be caused by any of these programs running during or prior to the installation of mSQL: SQL Server Management Studio, SQL Server Data Tools, or Visual Studio. To resolve the issue first close any running instances of the aforementioned software, then run the mSQL installer a second time.

If no luck after a 2nd reinstall, a reboot is recommended before installing a third time.


Was this article helpful?
0 out of 0 found this helpful

have a question or not finding what you're looking for?

Submit a ticket to get some help